Hi ,
We have SLT server with 2 configurations setup (schema) , DEV and QA. on one of these configurations we are using transformation with an include where it is calling a source system via RFC. Normally we would point SLT Dev to ECC dev , SLT QA to ECC QA etc but in this case we wanted to point SLT Dev to another system based on the current configuration ID.
I was trying to get that info from SY table in runtime but couldn't find a way to debug the include.
1. Is there a way to debug include in transformation in runtime ( I tried a hard code break point with no luck).
2. Can I find out using a case statment which configuration is being used ? this will drive the RFC to the correct source system.
Thank you,
Nick